Filter
Top Products
46
Corinex ADSL2+ Wireless Gateway G Configuration
Corinex ADSL2+ Wireless Gateway G
Field Description
PCR Peak Cell Rate (in cells/sec) is the cell rate, which the source
may never exceed.
SCR Sustain Cell Rate
MBS Maximum Burst Size - traffic parameter that specifies the
maximum number of cells that can be transmitted at the
Peak Cell rate.
CDVT Cell Delay Variation Tolerance
Auto PVC Auto Permanent Virtual Circuit, see PVC.
Bridged gateway profile and Connection
A pure bridged connection does not assign any IP address to the WAN interface.
NAT and firewall rules are not enabled. This connection method, as shown on next
picture, makes the Gateway act as a hub, and just passes packets across the WAN
interface to the LAN interface.
Use the following procedures to configure the gateway as a bridge.
1. From the Setup main page, click on New Connection.
The default PPPoE connection setup is displayed.
2. At the Type field select Bridge.
3. The Bridge connection setup page is displayed.