Setting Up the Reader
Product Reference Guide 7
Other connection types are described below and illustrated in Figure 2.
USB Connection —
Connect the reader to a USB port on the terminal/PC using the correct
USB cable for the interface type you ordered. Reference Figure 2.
IBM Connection —
Connect the reader to the IBM port on the terminal/PC using the cor-
rect IBM cable. Reference Figure 2.
Keyboard Wedge Connection —
The Keyboard Wedge cable has a ‘Y’ connection from
the reader. Connect the female to the male end from the keyboard and the remaining end at the
keyboard port at the terminal/PC. Reference Figure 2.
Figure 2. Other Interface Connections
Programming
The reader is factory-configured with a set of default features standard. After scanning the inter-
face barcode from the Interfaces section, you can select other options and customize your
reader through use of the instructions and programming barcodes available in the corresponding
features section for your interface and also the Data Editing and Symbologies chapters of this
manual.
NOTE
Specific cables are required for connection to different hosts. The
connectors illustrated above are examples only. Actual connectors
may vary from those illustrated, but the steps to connect the reader
remain the same.
U
S
B
I
B
M
K
e
y
b
o
a
r
d
W
e
d
g
e
or...
or...