Filter
Top Products
Adding and Replacing Parts 67
To replace the hard drive in the hard drive bay:
1
Complete the instructions in "Before You Begin" on page 65.
2
Turn the computer over, and remove the hard drive screws.
NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging. See the
safety instructions in your Product Information Guide.
3
Slide the hard drive out of the computer.
4
Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force, you may
damage the connector.
5
Insert the drive into the bay, and push the hard drive until it is fully seated in the bay.
6
Replace and tighten the screws.
7
Install the operating system for your computer.
8
Install the drivers and utilities for your computer.
screws (2)
hard drive