Filter
Top Products
Replacing the Optical Drive Board
1. Follow the procedures in Before You Begin.
2. Use the alignment posts on the computer base to correctly place the optical drive board.
3. Replace the two screws that secure the optical drive board to the computer base.
4. Slide the optical drive board cable into the connector on the optical drive board, and press down on the connector latch to secure the cable.
5. Replace the palm rest (see Replacing the Palm Rest).
6. Replace the keyboard (see Replacing the Keyboard).
7. Replace the power button panel (see Replacing the Power Button Panel).
8. Replace the module cover (see Replacing the Module Cover).
9. Replace the optical drive (see Replacing the Optical Drive).
10. Replace the battery (see Replacing the Battery).
Back to Contents Page
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.