Filter
Top Products
5. Remove the hinge cover (see Removing the Hinge Cover).
6. Use the pull-tab to disconnect the display cable from the system board, and then disengage the display cable from the cable channel.
7. Remove the four M2.5 x 5-mm screws (two on each side) that connect the display to the computer base.
8. Lift the display assembly away from the computer.
Replacing the Display Assembly
1. Thread the Mini-Card antenna cables back through the hole in the base of the computer so that they are accessible from the bottom of the computer.
1
display cable in cable channel
2
display cable pull-tab
3
M2.5 x 5-mm screws (4)
1
Mini-Card antenna cables
NOTICE: When removing the display assembly, carefully unthread the Mini-Card antenna cables through the computer base.