Filter
Top Products
48 About Your System
Unable to launch
System Services
image. System
halted!
System halted after F10
keystroke because System
Services image is either
corrupted in the system
firmware or has been lost due
to system board replacement.
The optional iDRAC6
Enterprise card flash memory
or BMC SPI flash may be
corrupted.
Restart the system and
update the Unified Server
Configurator repository to
the latest software to restore
full functionality. See the
Unified Server
Configuration user
documentation for
more information.
Restore the flash memory
using the latest version on
support.dell.com. See the
iDRAC 6 User Guide for
instructions on performing a
field replacement of the
flash memory.
Unexpected
interrupt in
protected mode.
Improperly seated memory
modules or faulty
keyboard/mouse
controller chip.
Reseat the memory modules.
See "Troubleshooting
System Memory" on
page 153. If the problem
persists, see "Getting Help"
on page 169.
Unsupported CPU
combination.
Unsupported CPU
stepping
detected.
Processor is not supported by
the system.
Install a supported processor.
See "Processor" on page 120.
Unsupported DIMM
detected. The
following DIMM
has been
disabled:
x.
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 106.
Table 1-3. System Messages (continued)
Message Causes Corrective Actions
R310HOM.book Page 48 Thursday, March 4, 2010 1:03 AM