Filter
Top Products
Adding and Replacing Parts 113
To replace the hard drive in the hard drive bay:
1
Follow the procedures in "Before You Begin" on page 109.
2
Turn the computer over, and remove the hard drive screws.
NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting
Against Electrostatic Discharge" in the Product Information Guide.
3
Slide the hard drive out of the computer.
4
Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage
the connector.
5
Slide the hard drive into the bay until it is fully seated.
6
Replace and tighten the screws.
7
Install the operating system for your computer. See "Restoring Your Operating System" on page 102.
8
Install the drivers and utilities for your computer. See "Reinstalling Drivers and Utilities" on page 100.
1 screws (2) 2 hard drive
1
2