Filter
Top Products
Installing the Power Connector
1. Place the power connector on its place in the computer.
2. Route the power-connector cable on its routing channels.
3. Install:
a. system board
b. system fan
c. ExpressCard cage
d. palmrest
e. display hinge
f. WLAN card
g. hard drive
h. optical drive
i. memory
j. keyboard
k. keyboard trim
l. base cover
m. battery
n. SD card
4. Follow the procedures in After Working Inside Your Computer.
Removing the Speakers
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. SD memory card
b. battery
c. base cover
d. keyboard trim
e. keyboard
f. memory
g. optical drive
h. hard drive
i. WLAN card
j. display hinge
k. palmrest
l. system fan
m. ExpressCard cage
n. system board
3. Perform the following steps:
a. Remove the speaker cable from the routing channels.
b. Remove the screws that secure the speakers from the computer.
c. Lift and remove the speakers from the computer.
33