Filter
Top Products
204 Management: Installing Array Components
Figure 15-3. Removing and Installing a 2.5" Hard-Drive Blank (MD3220 Only)
Installing a Hard-Drive Blank
1
If installed, remove the front bezel
. See
"Removing the Front Bezel" on
page 202.
2
Insert the hard-drive blank into the drive bay until the blank is fully seated.
3
Close the handle to lock the blank in place.
4
If applicable, replace the front bezel. See "Installing the Front Bezel" on
page 202.
Removing a Hard Drive
CAUTION: Many repairs may only be done by a certified service technician.
You must only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1
If installed, remove the front bezel
. See
"Removing the Front Bezel" on
page 202.
1 hard-drive blank 2 release tab
1 2
book.book Page 204 Tuesday, September 27, 2011 3:25 PM