Filter
Top Products
Chapter 2 Getting Started the BHT and System Menu
23
2.3 Preparation
2.3.1 Setting-up 1: Loading the battery cartridge
Before the first use of the BHT, be sure to load the battery cartridge as shown below. The battery
cartridge is not loaded in the BHT when shipped from the factory.
Into the BHT body
(1) Turn the BHT upside down.
(2) Slide the release buttons in the direction shown below and remove the battery cartridge cover.
(3) Push the battery cartridge into the BHT.
(To remove it, first make sure that the BHT is turned off. Slide the release buttons, remove the
battery cartridge cover, and pull up the battery pull strap.)
(4) Set the battery cartridge cover back into place and slide the release buttons to the original position.
(5) Place the BHT on the CU-200 to charge the rechargeable battery cartridge. (Refer to Section 5.5.)
Battery pull strap
Battery
cartridge
Battery
cartridge
cover
Release
button
Battery pull strap
Release button