Filter
Top Products
TX 4000 PCI SS7 Network Interface Board Installation Manual Verifying the installation
Verifying the board installation
Complete the following steps to verify that each board is successfully installed:
Step Action
1 Display a list of all of the TX boards detected in the system by entering the following command:
txcpcfg
txcpcfg displays the bus number, slot number, CP number, and CP model type of each detected
TX board. For example:
Bus Slot CP Number CP Model
5 7 1 TX 4000
5 8 2 TX 4000
If the CP number is listed as undefined, assign a CP number. For more information, refer to
Assigning a CP number on page 22.
2 Ensure that each installed and configured board in the system appears in the list of boards.
3 Display a list by CP number and board type of all the TX boards in the system by entering the
following command at the prompt:
cpmodel
cpmodel displays each TX board by model type and assigned CP number. For example:
Board #1 is a TX 4000
Board #2 is a TX 4000
4 Ensure that the boards listed by the txcpcfg utility in Step 1 are the same boards listed by the
cpmodel utility in step 3.
5 Perform board-level diagnostic tests on each new board to verify the installation by entering the
following command at the prompt:
txdiag -b boardnum
where boardnum is the CP number of the board.
txdiag indicates the successful installation of the CP 1 board.
TXDIAG V2.0: (c)Copyright 1998-2009 Dialogic Corporation. All Rights Reserved.
CP 1: NMI - Resetting...
CP 1: NMI - ...Reset Complete
CP 1: NMI - Starting test...
CP 1: NMI - SUCCESS CP 1: MEMSWEEP - Resetting...
CP 1: MEMSWEEP - ...Reset Complete
CP 1: MEMSWEEP - Starting test...
CP 1: MEMSWEEP - SUCCESSCP 1: INTR - Resetting...
CP 1: INTR - ...Reset Complete
CP 1: INTR - Starting test...
CP 1: TXDIAG - Resetting...
CP 1: TXDIAG - ...Reset Complete
Refer to the Dialogic® TX Series SS7 Boards TX Utilities Manual for detailed
information about txcpcfg, cpmodel, and txdiag.
Dialogic Corporation 41