Filter
Top Products
Monitoring capabilities from the command line
202
Commands for managing Mesh networks and nodes
Several commands are used to configure Mesh networks and display information and
statistics about the devices in the Mesh network: set mesh, display mesh, and info
zigbee_sockets.
set mesh
The set mesh command configures Mesh network settings for a ConnectPort X gateway.
Also displays current configuration parameters on the gateway Mesh node or of remote
nodes in the mesh (specified by the address option).
Configure Mesh network settings: command syntax
set mesh [options...] [device_settings...]
options:
state={off|on} {Enable mesh gateway}
address=device address {Specify device to set}
device_settings:
pan_id=0x0-0x3fff {PAN identifier}
dest_addr=address {Destination address}
delay_slots=0-3 {Random delay slots}
broadcast_hops=0-10 {Broadcast radius}
scan_channels=0x1-0xffff {Scan channels, bitfield}
scan_duration=0-7 {Scan duration, exponent}
join_time=0-255 {Node join time, sec}
join_notification=0-2 {Join notification}
node_id=0-20 chars {Node identifier}
discover_timeout=0-252 {Node discovery timeout, x 100 msec}
aggregation=0-255 {Aggregation route notification, x 10 sec}
power_level=0-4 {Transmit power level}
power_mode=0-1 {Power mode}
cca_threshold=36-80 {CCA threshold, -dBm}
sleep_period=32-2800 {Cyclic sleep period, x 10 msec}
device_type=0x0-0xffff {Device type identifier}
serial_rate=0-115200 {Serial interface data rate}
serial_parity=0-4 {Serial interface parity}