DES-2218 Ethernet Switch User’s Guide
Using the Console Interface
35
♦ Boot Protocol Set to either TFTP ONLY or
BOOTP&TFTP.
Applies only if the S/W Update Control is enabled.
♦ Boot Server IP Address The IP address of the TFTP server where
the configuration file is located. This entry is used only if the S/W
Update Control is enabled and your boot protocol is
tftp only; if
you are using
bootp-tftp
mode, or if Send BOOTP Request on
Power Up is enabled, the address will be obtained from the BOOTP
server.
♦ Boot File Name The pathname of the configuration file on your
TFTP server. If you are using D-View as your TFTP server, this is
the pathname of the
.CFG
file on your hard disk. This entry is used
only if your boot protocol is TFTP ONLY; if you are using
BOOTP&TFTP mode, or if Use Bootp to get IP after start up is
enabled, the pathname will be obtained from the BOOTP server.
Figure 6-12. Software Update Menu
For more information about DES-2218 configuration files, consult the
appendix. For detailed information about using the TFTP and BOOTP
servers, consult the D-View User’s Guide.