Filter
Top Products
VID group and press the “Remove the VID” button. To modify the VID group setting, select the VID group and change the setting, and press the “Apply”
button to save the settings.
Figure 18.
When you select Port VLAN setting, fill in each port’s PVID value between 1 and 4094.
Figure 19.
Trunk Setting
The Trunk function enables the Switch to cascade two devices with a double times bandwidth (up to 4000Mbps in full-duplex mode).
There are seven groups for trunk setting, each group has a fixed setting to choose from, Group 1~Group 6 for 10/100Mbps setting and
Group 7 for 10/100/1000Mbps setting
Figure 22. Trunk Settings
Mirror Setting
Port Mirroring is a method of monitoring network traffic that forwards a copy of each incoming and/or outgoing packet from one port
of a network switch to another port where the packet can be studied. It enables the manager to keep close track of switch performance
and alter it if necessary.
Configuring the port mirroring by assigning a source port from which to copy all packets and a sniffer port where those packets will
be sent.
The selection of the sniffer mode is as follow:
TX (transmit) mode: this mode will duplicate the data transmit from the source port and forward to the sniffer port.
RX (receive) mode: this mode will duplicate the data that send to the source and forward to the sniffer port.
Both (transmit and receive) mode: this mode will duplicate both the data transmit from and data that send to the source port, then it
will forward to the sniffer port.
Note: The fiber port does not support sniffer function.