Filter
Top Products
51
NETWORK menu
NETWORK menu
Item Operation
DHCP
(Dynamic Host
Conguration
Protocol)
Use the ▲/▼ buttons to turn DHCP on/off
ON
ó
OFF
• Select OFF when the network does not
have DHCP enabled.
• When the DHCP setting changes to ON, it takes a little time to
obtain IP address from DHCP server.
• Auto IP function will be assigned an IP address if the projector
could not obtain an IP address from server even if DHCP is ON.
IP ADDRESS
Use the ▲/▼/◄/► buttons to enter the IP
address. This function can only be used when
DHCP is set to OFF.
• The IP address is the number that identies
this projector on the network. You cannot
have two devices with the same IP address
on the same network.
• The IP ADDRESS “0.0.0.0” is prohibited.
SUBNET MASK
Use the ▲/▼/◄/► buttons to enter the same
subnet mask used by your PC. This function
can only be used when DHCP is set to OFF.
• The SUBNET MASK ”0.0.0.0” is prohibited.
Remember that incorrect network settings on this projector
may cause trouble on the network. Be sure to consult with
your network administrator before connecting to an existing
access point on your network.
From the NETWORK menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons, and press the ► cursor button or
ENTER button to execute the item. Then perform it according to the following
table.
See the User’s Manual - Network Guide for details of network operation.
NOTE • The factory default setting for DHCP is ON. You do not have to set up DHCP,
IP ADDRESS, SUBNET MASK or DEFAULT GATEWAY if your network has DHCP
enabled. (
User’s Manual - Network Guide)
• If you are not utilizing SNTP (
User’s Manual - Network Guide), then you must set
the date and time during the initial installation. Please refer to the item DATE AND TIME
in the following table (
52).