Filter
Top Products
Data Power Solutions Quick Start Guide
Copyright © 2006-2009 Eaton Corporation. All Rights Reserved.
10640205 February 2009
19
Step 5 – Arrange sleeves and tighten clamp screws
• Arrange the sleeves so that they are all within 10mm (3/8”) of the terminals.
• Tighten all cable clamp screws. Required torque: 1.5 – 2Nm (13.2 – 17.7 lb-in).
Tighten the screws of any unused clamps to prevent access to the dc output terminations.
Installing the External Batteries (if applicable)
This section applies to APS3-059, APS3-061 and APS6-059 dc power systems only.
One 48V battery string can be connected to APS3-059 and APS3-061, and up to three 48V
battery strings to APS6-059 dc power systems. A 48V battery string consists of either 24 Valve
Regulated Lead Acid (VRLA) 2 V cells or four VRLA 12 V monoblocs.
Because of the wide range of battery types and sizes available, we do not supply batteries
with the above mentioned power systems and therefore do not cover battery installation in
this guide. Always install batteries according to the relevant battery manufacturer’s
instructions.
Battery Sizing
Battery manufacturers provide various types of information for sizing batteries such as
constant current discharge and constant power discharge data. Your battery supplier will be
able to assist you with sizing the battery for your application. Before a battery can be sized,
the following information is required.
Required backup time, minimum cell voltage (typically 1.83V/cell), load power & operating
temperature
In data applications most loads are constant power for a specified backup time. Therefore, for
sizing a battery for the required backup time, constant power discharge data should be used.
Batteries for use in North America must be a UL recognized type, category BAZR2.
Battery Location
Valve Regulated Lead Acid (VRLA) batteries emit very small amounts of hydrogen gas into
the surrounding atmosphere under normal float charging conditions. For that reason
batteries should never be installed in a sealed enclosure or cabinet. Install the batteries in a
well-ventilated location to prevent accumulation of hydrogen gas to flammable or explosive
levels.
Building air conditioning and ventilation systems already in place for optimum equipment
operation and comfort of personnel usually meet or exceed VRLA battery ventilation
requirements. For specific battery ventilation requirements, always refer to the battery
manufacturer’s installation instructions. Avoid:
• Installing the batteries next to any heating source or under air ducts.
• Exposing part of a battery string to direct sunlight.
• Any other locations that would cause temperature variations within the batteries.