Filter
Top Products
52
2.1 Port Configuration
This page can change the status of each port. Press <Space>
key to change configuration of each item.
1. InRate(100K/unit): You can set input rate control, per unit is
100K. The valid range is 0~1000.
0: disable rate control.
1~1000: valid rate value.
2. OutRate(100K/unit): You can set output rate control, per
unit is 100K. The valid range is 0~1000.
0: disable rate control.
1~1000: valid rate value.
3.Enable: You can disable or enable this port control. “Yes”
means the port is enabled, “No” means the port is disabled.
4.Auto: You can set auto-negotiation mode as Auto,
Nway_Force or Force of each port.
5.Spd/Dpx: You can set 100/10Mbps speed on port 1~port24;
1000/100/10Mbps speed on port25~port26 (Gigabit Switch),
100/10Mbps speed on port25~port26 (Fast Ethernet Switch)
and set full-duplex or half-duplex mode.
6. Flow Control:
Full: Displays the flow control status is enable/disable in full