Filter
Top Products
W ireless L AN AP Configuration
Start IP/End IP
You can designate a particular IP
address range for your DHCP server to
issue IP addresses to your LAN Clients.
By default the IP range is from: Start IP
192.168.2.100 to End IP 192.168.2.200.
Domain Name
You can specify the Domai n Name for
your Access Point.
Lease Time
The DHCP Server when enabled will
temporaril y give your LAN client an IP
address . In the Lease Time setting you
can specify the time period that the
DHCP Server lends an IP address to
your LAN clients. The DHCP Server will
change your LAN client’s IP address
when this time threshold period is
reached.
Click Apply button at the bottom of the screen to save the
above configurations. You can now configure other advance
sections or start using the Access Point.
3.2.7 Configuration Tool
The Configuration Tools screen allows you to save (Backup)
the Access Point’s current configuration setting. Saving the
configuration settings provi des an added protecti on and
convenienc e shoul d problems occur with the Access Point
and you have to reset to factory default. When you save the
configuration setting (Backup) you can re-load the saved
configuration into the Access Poi nt through the Restore
selection. If extreme problems occur you can use the Restore
to Factory Default selection, this will set all configurations to
its original default setti ngs (e.g. when you first purchased the
Access Point).
37