Filter
Top Products
-7 -
Programming EZ 250
(Best viewed in 1024 x 768 or higher)
1. To connect your EZ 250 controller to your EZlink Hub interface take two
(2) standard cat5 cables and connect the first cable between EZlink 1 port
on the interface and EZ 1 port on the controller and the second cable to
the EZlink 2 port of the interface and EZ 2 port of the controller.
2. Take a DB9 female to a DB9 female cable and plug one end into RS-232-
2 port on the interface and the other into your computer
3. Set the dip switches on the EZlink interface (see page 25)
4. Connect the power supply to the EZlink hub .
5. Then choose which level of programming you will need
In this section the different ways to program the EZ 250 will be explained.
Programming using a Saved file
1. Select EZ 250 under EIKI by clicking on the start menu, then all
programs, then EIKI and select EZ 250
2. Select File
3. Then Open
4. Select saved file