Filter
Top Products
- 16 -
Timer Programming
This Feature allows you to select a timer that will shut off the devices that are
contacted to the EZ 250 for the time you select.
1. Select Timer
2. Select Setup
3. Type in how many hour(s) you need
4. Select OK
5. Example: a four hour timer - the devices that are connected to the EZ 250
will shut down after four hours. The LEDs on the bottom of the EZ 250 are
indicators to let you know how much time is left before the devices shut
down. The first LED will shut off after 1 hour leaving three lit LEDs
indicating that there are three hours left. After the second hour only two
LEDs will remain lit. After the third hour only one will remain lit. This state
leaves one hour before the devices will shut down. At any time during this
process pressing the ON button will reset the timer to four hours and all
four LEDs will light up again.