Filter
Top Products
-8 -
Reset Button
Reset Button
5. Select open Note: a pre-existing file may be modified for current user specs once it is opened.
6. Select the Upload New Configuration to Control Button
Or
7. The software will prompt you to press the reset button. (reset button is
located on the back of the EZ 250)
8. After the programming status disappears disconnect the cables from the
computer and press the reset button on the back of the EZ 250 and you
are ready for the installation of the EZ 250
Standard Programming
1. Select EZ 250 under EIKI by clicking on the start menu, then all
programs, then EIKI and select EZ 250
2. Select Projector (from the top of the EZ 250 software)
3. Select Model
4. Select Control Port 1