Filter
Top Products
AMC-S402 Installation
6806800H60A AMC-S402 Installation and Use 7
The use of th tion with the Blue LED. Please refer
to the text ns on insertion and
extraction.
e Module Handle is used in conjunc
and table below for more detailed instructio
ector Latch
stalling the AMC Module
ts
.
n. If a
lot or system
that you have taken the necessary antistatic precautions.
sired AMC
from the selected AMC slot, if necessary.
Figure 3. AMC Module Injector / Ej
2.7 In
This section describes a recommended procedure for installing a board module in a
chassis.
Before you install your module, please read all cautions, warnings, and instructions
presented in this section.
Handling modules and peripherals can result in static damage. Use a grounded wrist
strap, static-dissipating work surface, and antistatic containers when handling and
storing componen
Insert the board by holding the Module Handle–do not exert unnecessary pressure
on the faceplate.
Use ESD
Wrist Stra
p
!
Cau
Hot swap complian
t modules may be installed while the system is powered o
module is not hot swap compliant, you should remove power to the s
tion
before installing the module.
1. Verify
2. Inspect th
e ATCA carrier board or MicroTCA chassis, and locate the de
slot.
3. Remove the slot filler panel
4. Carefully align the edges of the module with the rail guides in the appropriate
slot or carrier card.