Filter
Top Products
Network Tools
Network Tools Screens 12-3
Refer to Table 12-1 for a list of the commands.
• Special Commands – Allow the user to exit from Network Tools. The commands are done, quit,
and exit.
Table 12-1 Built-in Commands
alias arp arp_learn atm_stp_state
1
1. The atm_stp_state command only displays when an HSIM or VHSIM is installed that supports ATM, such as the
HSIM-A6DP or VHSIM2-A6DP.
bridge cdp defroute dynamic_egress
ev gigabit_port_mode
2
2. The gigabit_port_mode command only displays when a gigabit interface module is installed.
lg_frame_admin link_trap
loopback_detect MAC_lock disable MAC_lock enable MAC_lock status
MAC_lock trap
disable
MAC_lock trap
enable
netstat non_bridge_if_num
passiveStp ping radius rate_limit_mode
reset sat_size suppress_topology_
traps
show
show mac soft_reset stpEdgePort stpForceVersion
stpPointToPointMAC stpLegacyPathCost stpPort stpRealTimeMsgAge
stpStandby telnet timed_reset timed_soft_reset
traceroute vrrpPort
NOTES: The conventions used in describing the commands in Network Tools are as
follows:
Arguments enclosed by [ ] are required.
Arguments enclosed by < > are optional.
In the following command examples, the information entered by the user is shown in
bold font
.
To abort the output or interrupt a process, press the CONTROL key and c key
simultaneously, designated as ^C here.