Support User Manuals

Enterasys Networks B3G124-48P Switch User Manual

Open as PDF

of 80

Considerations Prior to Installation

3-2 Hardware Installation

Considerations Prior to Installation

Wheninstallingtheswitch,notethefollowing:

•Beforestartingtheinstallationprocedure, notifythenetworkadministratorofthe

installation.

•Followtheinstallationproceduresintheorderaspresentedinthisguide.

•DonotconnecttheswitchtothenetworkuntilyouhaveestablishedthecorrectIP

address.

Required Tools

APhillipsscrewdriverisrequiredtoinstalltheswitchintoarack.

Unpacking the Switch

Unpacktheswitchas follows:

1. Opentheboxandremovethepackingmaterialprotectingtheswitch.

2. Verifythatthe contents ofthecartoncontainstheitemslistedinTable 3‐1.

3. Removethetapeseal onthe non‐conductivebagtoremovetheswitch.

4. Performavisualinspectionoftheswi tchforany

signsofphysicaldamage.Contact

Enterasys Networksifthereareanysignsofdamage.Referto“GettingHelp”on

page xviiifordetails.

Table 3-1 Contents of Switch Carton

Item Quantity

B3G124-24Por B3G124-48P switch device 1

Rack mounting bracket 2

M3x6-mm flathead screws 8

Rubber feet with adhesive backing for installation on a flat surface 4

AC power cord (The type of power cord is country-dependent.) 1

This installation guide 1

Customer Release Notes 1

URL notice card 1

previous next