Support User Manuals

Enterasys Networks B3G124-48P Switch User Manual

Open as PDF

of 80

Connecting to Console Port for Local Management

SecureStack B3 Installation Guide 3-21

Figure 3-11 Connecting a VT Series Terminal

Connecting to a Modem

Toconnectamodemtoaswitchmodemport(Figure 3‐12),useaUTPcableterminated

withaDB9femaleconnectorandaDB25maleconnector,andproceedasfollows:

1. ConnecttheDB9femaleconnectoratoneendofthecabletotheDB9maleConsole

portconnectoronthe

switch.(IfthereisaswitchdesignatedastheManager,connect

toitsConsoleport.)

2. PlugtheDB25maleconnectorattheotherendofthecableintothemodem

communicationsport.

3. TurnonthemodemandmakesuretheremotemodemisON.

4. WithyourPCconnectedtotheremotemodem,

configureyourVTemulationpackage

withthefollowingparameters:

Whentheseparametersareset,theStartupscreenwilldisplay.Iftheswitchesareina

stackedconfiguration,proceedto“Connecting totheNetwork”onpage 3‐22.

1 DB9 female cable connector 4 DB25 female connector

2 Serial interface cable 5 PC with VT emulation application

3 DB9 male Console port connector

Parameter Setting

Mode 7 Bit Control

Transmit Transmit=9600

Bits Parity 8 Bits, No Parity

Stop Bit 1 Stop Bit

previous next