Filter
Top Products
Port Priority and Classification Configuration Commands
Configuring Priority Classification
9-18 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
9.3.4.2 set priority classification
Use this command to create a classification rule that will assign traffic to a priority based on Layer
2/3/4/ rules.
set priority classification priority_value data_meaning data_value [data_mask]
{create | disable | enable}
Syntax Description
Command Defaults
Data masks are required only for classification types requiring a second
data_value. For details, refer to Table 9-1.
Command Type
Switch command.
Command Mode
Read-Write.
Command Alternative (v2.05.xx and higher)
set policy classify (Section 8.3.2.2)
priority_value Specifies a port priority number (0 through 7) to which the
frame classification is applied.
data_meaning Specifies the parameters used to classify frames. Refer to
Table 9-1 for the list of data_meanings and associated
protocol types and classifications.
data _value Specifies the code of a predefined classifier. The range of
values is dependent on the data_meaning. Refer to
Table 9-1 for the limitations.
data_mask (Not required for most data values). Specifies a value
dependent on the data_value entered. For details, refer to
Table 9-1.
create | disable |
enable
Creates, disables or enables a priority classification
according to the parameters entered.
NOTE: Classification rules are automatically
enabled when created.