Enterasys Networks E1 Series Network Router User Manual


 
Security Configuration Command Set
Configuring MAC Locking
14-56 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
Command Defaults
If disable is not specified, the MAC locking autostatic function will be enabled.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable the MAC locking autostatic function on Fast Ethernet front
panel port 3:
14.3.4.12set maclock autostatic isl
Use this command to enable or disable automatic learning of the MAC locking autostatic public
VLAN. In rare cases, if the ingress VLAN of traffic to the switch is different from the egress
VLAN(s) traffic use to leave the switch, the this command can be used with the set maclock
autostatic publicvlan command (Section 14.3.4.13) and the set maclock autostatic publicmac
command (Section 14.3.4.14) to automatically assign MAC-VID bindings to both the ingress and
egress ports to improve switch performance.
set maclock autostatic isl port-string [enable | disable]
port-string Specifies the port(s) on which to enable or disable the
MAC locking autostatic function. For a detailed
description of possible port-string values, refer to
Section 4.1.2.
enable | disable (Optional) Enables or disables the MAC locking
autostatic function.
Matrix>set maclock autostatic fe.0.3 enable
NOTE: Enterasys Networks recommends that you contact Technical Support before
attempting to use this feature.