Connecting to a Console Port for Local Management
Connecting to a Modem
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 2-5
3. Connect the RJ45-to-DB25 adapter to the communications port on the modem.
4. Turn on the modem and configure your VT emulation package with the following parameters:
5. When these parameters are set, the Matrix E1 startup screen will display.
2.1.4.1 Configuring the Modem to Not Send Login Requests
If the modem attempts to auto-connect or sends requests to the console port, the console port will
treat these actions as login requests, and will fail the login and lockout the console session as a
result.The modem should be configured to not send requests to the console port when attached.
Suggested settings are below. Often, there is a set of dip-switches on the bottom of the modem that
can be adjusted, as in the following example:
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=9600
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit
Switch Setting Action
1 on DTR always on
2 off Verbal result codes
3 off Suppress result codes
4 off Echo offline commands
5 off Auto answer ring
6 on Carrier detect override
7 off Display all result codes
8 off Disable AT command set
9 off Disconnect with +++
10 on Load $FO settings