Enterasys Networks RBT-8110 Switch User Manual


 
Wireless Switch Configuration Tasks
RBT-8110 Wireless Switch Installation Guide 3-3
quickstart Command Procedure
Torunthequickstartcommand:
1. UsingthenullmodemcableshippedwiththeRBT8100,attachaPCtotheRoamAbout
wirelessswitch’sserialconsoleport.Usethesemodemsettings:
9600bps,8bits
•1stop
•Noparity
Hardwareflowcontroldisabled
2. PressEnterthreetimes,todisplayauserna meprompt(Username:),a
passwordprompt
(Password:),andthenacommandpromptsuchasthefollowing:
RBT-8110-aabbcc>
(Eachswitchhasauniquesystemnamethatcontainsthemodelnumberandthelasthalfof
theswitch’sMACaddress.)
3. Accesstheenabledlevel(theconfigurationlevel)oftheCLI:
RBT-8110-aabbcc> enable
4. PressEnterattheEnterpasswordprompt.
5. Typequickstart.Thecommandasksyouaseriesofquestions.Youcantype?formorehelp.
Toquit,pressCtrl+C.Thefollowingexamplecodeacceptsthedefaultsforsystemnameand
countrycode,anddoesnotconfigureSSIDs,userinformation,or
distributedaccesspoints.
RBT-8110-aabbcc# quickstart
This will erase any existing config. Continue? [n]: y
Answer the following questions. Enter '?' for help. ^C to break out
System Name [RBT-8110]:RBT-8110-aabbcc
Country Code [US]: US
System IP address []: 182.29.1.250
System IP address netmask []: 255.255.255.0
Default route []: 182.29.1.1
Do you need to use 802.1Q tagged ports for connectivity on the default VLAN?
[Y/N]: y
Specify the port number that needs to be tagged [1-2, <CR> ends config]: 2
Specify the tagged value for port [2] [<CR> ends config:] 100
Specify the port number that needs to be tagged [1-2, <CR> ends config]:
Enable WebView [y]: y
Admin username [admin]: rbtadmin
Admin password [mandatory]: letmein
Enable password [optional]: enable
Do you wish to set the time? [y]: y
Enter the date (dd/mm/yy) []: 31/03/06
Is daylight saving time (DST) in effect [n]: n
Enter the time (hh:mm:ss) []: 04:36:20
Enter the timezone []: EST
Enter the offset (without DST) from GMT for 'PST' in hh:mm [0:0]: -5:00
Do you wish to configure wireless? [y]: y
Enter a clear SSID to use: public
Note: Do not attempt to connect a monitor, keyboard, or mouse to the switch. Use only a null
modem cable connected to the serial console port.