Support User Manuals

Enterasys Networks RBT-8110 Switch User Manual

Open as PDF

of 36

Wireless Switch Configuration Tasks

3-8 Configuration

6. EnabletheMSSDNSclient:

RBT-8110# set ip dns server enable

7. Enabletheauto‐configoption:

RBT-8110# set auto-config enable

8. Savetheconfigurationchanges:

RBT-8110# save config

9. Resettheswitchbyusingoneofthefollowingmethods:

•Enterthefollowingcommand:

RBT-8110# reset system

•Turnthepowerofftotheswitch,andthenturnthepowerbackon.

Example 4: Deployment Site Has DHCP But Local DNS Domain Differs From

Corporate DNS Domain

ThedeploymentsiteinthisexamplehasaDHCPserver,sotheswitch’sDHCPclientisenabled.

StaticIPaddressanddefaultrouter(gateway)informationarenotrequired.Thesitealsohasa

localDNSserver.However,thelocalDNSdomainnameisdifferentfromthecorporateDNS

domainnamewhere

theRASMserverislocated.ThestaticDNSconfigurationontheswitch

overridestheDNSconfigurationfromtheDHCPserver.

1. ConfigureaVLAN:

RBT-8110# set vlan 1 port 1

2. EnabletheDHCPclientonVLAN1:

RBT-8110# set interface 1 ip dhcp-client enable

3. ConfigurethedefaultDNSdomainname:

RBT-8110# set ip dns domain customer.com

4. ConfigureDNSserverinformation:

RBT-8110# set ip dns server 192.168.11.2

5. EnabletheMSSDNSclient:

RBT-8110# set ip dns server enable

6. Enabletheauto‐configoption:

RBT-8110# set auto-config enable

7. Savetheconfigurationchanges:

RBT-8110# save config

8. Resettheswitchbyusingoneofthefollowingmethods:

•Enterthefollowingcommand:

RBT-8110# reset system

•Turnthepowerofftotheswitch,andthenturnthepowerbackon.

previous next