Filter
Top Products
Epson PowerLite Cinema 200 Projector
1/04 Epson PowerLite Cinema 200 Projector - 5
Locking the Projector
You can lock the projector to prevent the image from being
accidentally changed once it’s adjusted, and to keep children
from using the projector without adult supervision.
1. Press the
Menu button on the remote control.
2. Use the menu navigation buttons to open the
Setting menu,
then open the
Operation menu and select Lock Setting.
3. Choose from these options:
❏
Focus Lock to prevent the focus from being changed.
❏
Zoom Lock to prevent the picture size from being
changed.
❏
Child Lock to make it more difficult to turn on the
projector from the control panel (but does not affect
operation of the remote control).
To turn on the projector, either use the remote control,
or press and hold the projector’s P
Power button for at
least 3 seconds.
❏
Key Lock to disable all the buttons on the projector’s
control panel.
Basic Image Adjustments
Once the projector is turned on, use these functions to adjust
the image.
Selecting the Image Source
If you don’t see the image you want, press the Source button
on the remote control that corresponds to the port to which
your video equipment is connected. For example:
Note: If you still don’t see an image after selecting the source, check
the troubleshooting tips on page 7. You can also use the Source
button on the projector’s control panel.
Focusing and Zooming the Image
To adjust the sharpness or size of the image:
1. Press the
Focus or Zoom button on the projector or remote
control.
You see this screen:
2. Use the arrow buttons to adjust the image.
Note: If you use the remote control, you can stand close to the screen
while focusing the image. This lets you adjust the picture more
precisely.
3. Press
ESC when done.
Inverting and Mirroring the Image
If the image is upside-down or backwards, use the Projection
function to adjust it:
1. Press the
Menu button on the remote control.
2. Use the menu navigation buttons to open the
Setting menu,
then open the
Screen menu and select Projection.
3. Choose from these options:
❏
Front if the projector is located in front of the screen (for
example, on a table).
❏
Front/Ceiling if the projector is located in front of the
screen and mounted overhead.
❏
Rear if the projector is located behind the screen.
❏ Rear/Ceiling if the projector is located behind the screen
and mounted overhead.
Selecting the Input Signal
If you’re using the projector’s Input A port, select the correct
setting for the type of video equipment you’ve connected to it:
1. Press the
Menu button on the remote control.
2. Use the menu navigation buttons to open the
Setting menu,
then open the
Input Signal menu and select Input A.
3. Choose from these options:
❏
YCbCr for a video player that outputs an NTSC signal.
❏
YPbPr for a video player that outputs an HDTV signal.
❏
RGB-Video if your video player outputs an RGB video
signal.
To select the image source
connected to the Video port . . . . . . press the Video button