Filter
Top Products
Paper handling
Paper does not feed properly from the sheet feeder.
Cause What to do
The paper may have been
loaded too deeply into the
printer.
Remove the paper and gently reinsert
it straight up and down into the
printer.
Too many sheets are loaded
in the sheet feeder.
Take the paper stack out of the feeder,
remove some sheets, and reload the
stack. Load paper only up to the arrow
mark on the left edge guide.
The edge guides are not set
correctly.
Adjust the guides against the stack of
paper. See “Loading Plain Paper” on
page 3-2.
Paper is jammed in the paper
path.
Turn off the printer and gently pull all
of the paper out of the printer. If it
tears and pieces remain inside the
printer, open the printer cover; then
remove any remaining pieces of paper.
The paper is curled or folded. Use flat, undamaged paper.
The paper is old or creased. Use only new, smooth sheets of paper.
The paper’s size is not
compatible with the printer.
Use paper that meets the paper
requirements for this printer. See
“Paper” in the Appendix.
The paper is too thin. Make sure the paper meets the paper
requirements for this printer. See
“Paper” in the Appendix.
L
Hudson++ Ref. Guide
Rev.d
A5 size Chapter 6
04-30-98 DR, pass 3
6-12
Troubleshooting