Filter
Top Products
Using the Remote Control
37
Using the Remote Control
The remote control uses a line-of-sight infrared signal. To use the
remote control, point it towards one of the remote control receivers
located at the front and back of the projector.
You can use the remote control up to about 32.8 feet (10 meters) from
the projector. (This distance may be shorter if the remote control
batteries are low.) You must also be within a
±
30
°
angle from the front
or rear sensor.
Note: The projector may not respond to remote control commands in these
conditions: ambient light is too bright; a certain type of fluorescent light is
present; a strong light source (such as direct sunlight) shines into the
bottom
multi-purpose button
pointer button
top
multi-purpose
button
pro-ch2.fm Page 37 Monday, November 10, 1997 1:36 PM