Filter
Top Products
4 Network Setup
Network Setup
This section provides detailed instructions for setting up your product on a
wireless or wired network.
Before you begin, make sure you set up your product as described on the
Start Here sheet. Then follow the steps in one of these sections to set up the
product on your network:
■ For wireless network setup, see below.
■ For wired network (Ethernet
®
) setup, see page 18.
Wireless Network Setup
The steps in this section provide detailed instructions for setting up your product
on a wireless network.
You will need to install the software on every computer that will print to your
product. Temporary use of a USB cable (not included) is recommended for the
first installation only. After the printer is connected to the network, you will be
prompted to remove the USB cable.
If you are using Mac OS X 10.6 or don’t have a USB cable, you can use the
buttons on the printer to select wireless settings instead.
Note:
If you have trouble setting up your product, see “Network Problems” on page 50.
■
If this is the first time that you’re installing the product, see “Installing for the
First Time” on page 5.
■ If your product is already on your wireless network and you need to set up
additional computers to print to the product, see “Setting Up Additional
Computers” on page 14.