Filter
Top Products
Epson PowerLite 6110i
12/07 11
Using the Remote Control
The remote control uses a line-of-sight infrared signal. It lets
you access the projector’s features from anywhere in the
room—up to 19.7 feet (6 meters) away. (This distance may be
shorter if the remote control batteries are low.)
If the projector does not respond to remote control
commands, check the following:
❏ If you’re using the remote control for the first time, make
sure the batteries are installed.
❏ The remote control’s batteries may not be installed correctly
or may be low on power. To change the batteries, see
“Replacing Remote Control Batteries” in the next column.
❏ Make sure you are within 19.7 feet (6 meters) of the
projector, and within range of the projector’s front or back
sensor (approximately 30° to the left or right and 15° above
or below).
❏ Dim the room lights and turn off any fluorescent lights.
Make sure the projector is not in direct sunlight. Strong
lighting, especially fluorescent lights, may affect the
projector’s infrared receivers. Also, turn off any nearby
equipment that emits infrared energy, such as a radiant
room heater.
❏ Make sure the projector’s remote receivers aren’t turned off
in the projector’s Settings menu. (See the User’s Guide for
more information.)
Using the Navigation Buttons
The remote control has various buttons that let you navigate
the projector’s help and menu systems; they also let you use
the drawing tools to highlight your presentation.
Note: The projector has
equivalent buttons that you can
use on its control panel:
Replacing Remote Control Batteries
When the batteries run out, follow the steps below to replace
them. The remote control requires two AAA alkaline batteries.
Note: The remote control automatically shuts off when it detects a
button being pressed for more than 60 seconds. This conserves
battery life. It can be helpful, for example, when the remote is in a
carrying case and the Power button is accidentally pushed.
Caution: When replacing batteries, take the following precautions:
❏ Replace the batteries as soon as they run out. If a battery leaks,
wipe away the battery fluid with a soft cloth. If fluid gets on your
hands, wash them immediately.
❏ Do not expose batteries to heat or flame.
❏ Dispose of used batteries according to local regulations.
❏ Remove the batteries if you won’t be using the remote control
for a long period of time.
1. Press in the tab and lift to remove the battery cover.
2. Remove the old batteries, then insert the new ones as
shown.
Pointer button
(controls pointer
movement)
Esc buttonEnter button
Arrow buttons
Enter button
Esc
button
Menu
button