Filter
Top Products
Epson PowerLite 6110i
12/07 13
Replacing the Air Filter
Replace the air filter (or optional smoke filter) when you see
the
Check or Replace the air filter message. Dust clogs
prevent proper ventilation and can cause overheating and
damage the projector.
To obtain a replacement air filter or smoke filter, contact your
Epson authorized reseller. To find the nearest reseller, call
800-GO-EPSON (800-463-7766). Or you can purchase
online at www.epsonstore.com (U.S. sales) or www.epson.ca
(Canadian sales).
Follow these steps:
1. Turn off the projector and unplug the power cord.
2. Lift the air filter cover by pulling up the tabs.
3. Remove the filter by pulling it straight out from the center.
4. Insert the new filter with the tabs facing the front of the
projector.
5. Close the air filter cover.
6. Reset the air filter timer as described in the next section.
Resetting the Air Filter Timer
1. Plug the projector in and turn it on.
2. Press the
Menu button on the remote control, select Reset
Air Filter Time
from the Reset menu, then press Enter.
3. When you see the confirmation message, select
Yes, then
press
Enter.
4. When you’re finished, press
Menu to exit the menu system.
Note: The air filter usage timer shows 0H until you’ve used the
filter for at least 10 hours.
Replacing the Lamp
Although lamp life results vary depending on environmental
conditions and usage, the projection lamp typically lasts about
3400 hours in high brightness mode or 3900 hours in low
brightness mode. It is time to replace the lamp when:
❏ The projected image gets darker or starts to deteriorate.
❏ The message
Replace the Lamp appears on the screen and
when the lamp comes on and the lamp warning light
flashes orange. To maintain projector brightness and image
quality, replace the lamp as soon as possible.
❏ The lamp warning light flashes red (the lamp is burnt
out).
Note: Turn off the projector when not in use to prolong the life of
the projection lamp.
You can see how long the lamp has been in use by checking
the
Lamp Hours option in the projector’s Info menu. (See the
User’s Guide for more information.)
Contact your Epson authorized reseller for a replacement
lamp and request part number
V13H010L45. To find the
nearest reseller, call 800-GO-EPSON (800-463-7766). Or
you can purchase online at www.epsonstore.com (U.S. sales)
or www.epson.ca (Canadian sales).
Follow these steps to replace the lamp:
1. Turn off the projector.
2. When the P Power light stops flashing, unplug the power
cord.
Warning: Let the lamp cool fully before replacing it.
In the unlikely event that the lamp has broken, small glass
fragments may be present and should be removed carefully to
avoid injury.
3. Let the projector cool for at least an hour (if it has been on).
The lamp is extremely hot immediately after use.