Filter
Top Products
Printing Problems
The printer stops printing and the display reads PAPER OUT
or
TONER OUT.
Replace the component specified. See Chapter 5 for paper
loading instructions. See Chapter 6 for toner cartridge
replacement instructions.
The printout is not what you expected.
The font you selected with software commands cannot be printed.
The correct orientation (portrait or landscape) may not be
selected. Make sure that the orientation (portrait or landscape)
matches the selected font. The correct font is not selected if the
font does not contain the selected orientation.
The font you selected with your software may not be available.
Be sure you have installed the correct font cartridge.
Characters not belonging to the selected symbol set are being printed.
The expected symbol set may not be available in the printer. Be
sure you have installed the correct font cartridge.
The correct symbol set may not be selected. Specify the desired
symbol set (containing international characters or symbols) with
your software or with SelecType. Available symbol sets in
SelecType vary depending on the printer mode selected. See
Chapter 4 or Appendix C for more information.
All the text is printed on the
same
line.
A line feed command is not being sent at the end of each line of
text. If you are using the parallel interface, you may be able to
correct this problem by setting the SelecType Level 2
AUTOFEED option to on. See Chapter 4.
Text is printed with an extra blank line in between printed lines.
An extra line feed signal is probably being sent. If you are using
the parallel interface, you may be able to correct this problem by
setting the SelecType Level 2 AUTOFEED option. See Chapter 4.
7-18
Troubleshooting