Filter
Top Products
SelecType Options
I/F CONFIG
The interface configuration option allows you to change the settings
for either of
the
built-in interfaces, the parallel or the serial. First
press to move to the channel selection submenu.
Press to change the channel, if necessary; then press .
The PARALLEL option has these three submenus:
SLCTIN
AUTOFEED
BUSY DELAY
SLCTIN
OFF
ON
* OFF
With SLCTIN set to off, the printer is continuously selected and
device control codes DC1 and DC3 are ignored. In almost all cases,
leave SLCTIN set to off. When SLCTIN is on, the SLCTIN signal goes
HIGH at power-on and the control codes DC1 and DC3 are valid.
SelecType
4-23