Epson C82315 Network Card User Manual


 
If your system
Is...
and the Epson
printer you are
using is...
the emulation and you
you should
should select
select is...
one of the
following
host system
settings
System 36,
9/24/48 element
4214
4214 model 2
System 38, AS400
dot matrix printer
and 5294 or 5394
or laser printer
remote controller
(using ESC/P
commands)
System 34 or 5251
9/24/48 element
5224
5224 (2P)
m12 remote
dot matrix printer
5225 (2P)
controller
or laser printer
5258 (P)
(using ESC/P
commands)
You should keep the following in mind when selecting the emulation.
Only the 3812 emulation supports HP laser printer commands.
If you have a choice between the 5224 and 4214 emulations, you should select
4214. The 4214 emulation adds control of the following features: lines per inch,
pitch, graphics, print quality, and single-sheet handling.
If your printer supports Epson Job Language (EJL) commands, do not change the
printer mode using the EJL commands or the command-pass-thru feature while
the interface is installed. Also you may not be able to change the printer mode
using the control panel.
Never select the PostScript™ printer mode while this interface is installed.
PREPARING TO INSTALL THE INTERFACE CARD
Before installing this interface card you may need to set several jumpers,
depending
on
the following factors:
The type of Epson printer you are using
The type of IBM printer you want the interface to emulate
The type of twin-axial connector your host system uses
3