Filter
Top Products
FONT ID
The 3812 emulation uses IBM font ID’s to switch from one HP font to another.
Only certain IBM font ID's can be used as the system default. These are noted by
an asterisk (*) in the Font ID table in Appendix A-3 of this manual.
You specify the default font ID for your printer when you configure the printer on
the IBM host. Have your system operator set your default to the font ID you use
most and then change as necessary with a printer override, OCL command, or
word processing font ID.(See Appendix A-3 for font ID table.)
PAPER SIZE AND ENVELOPES
The 3812 emulation supports the following paper sizes:
Letter
8.5 x 11 inches
Legal
8.5 x 14 inches
A4
210 x 297 mm (8.27’
x
11
.69’)
Executive
7.25 x 10.5 inches
Epson printers support the following envelope sizes:
Commercial
10
9.5 x 4.125 inches
Monarch
7.5 x 3.875 inches
DL
220 x 110 mm (8.66’
x
4.333
CS
229 x 162 mm (9.02’ x 6.38”)
You must send the paper and envelope dimensions from the IBM host to the
printer in order for the proper size to be selected. You can use interface setup
commands to select A4 size paper as the default or to feed paper regardless of
size.
JUSTIFICATION
The 3812 emulation supports right hand justification for all fixed pitch fonts as well
as proportional font ID
S
158, 159, and 162 (found in the 5410 font cartridge).
INTERFACE TEST MODES
In addition to the self-test described in the section on installing the interface, the
C82315* has four other tests you can perform: hex print, communications test,
interface diagnostics, and the interface diagnostic loopback.
20