Filter
Top Products
HP Lase Jet II mode
Switch
Off
6
Sets orientation automatically
during Computer Output
Reduction
7
Sets orientation automatically
during Computer Output
Reduction
On
Sets orientation to landscape
during Computer Output
Reduction
Sets orientation to Portrait
during Computer Output
Reduction
Switch
Off
On
8
Selects the C823W interface
Selects the printer’s built-in
card
interface
PERFORMING A SELF TEST
To verify the interface is installed and the settings are correct, perform an interface
self test according to the following steps.
1. Turn on the printer and load paper. Make sure the cable address (set with
switches 1, 2, and 3) is not set to 7.
2. Press the TEST button on the interface. The printer then prints out a list of the
jumper, switch, and feature settings, similar to the self test sample printout shown
in Appendix A-l.
The name of the printer printed in the self test may differ from your
printer’s actual model name.
3. Turn the printer off to end the self test.
If the warning message is printed, it indicates the interface’s emulation mode
differs from the emulation mode selected by your printer.
CONNECTING TO THE HOST COMPUTER SYSTEM
After you confirm the interface is installed and settings are correct, you can
connect it to the host system according to the following steps.
8