Filter
Top Products
Configuring the printer
3-3
3.2 Standard Configuration
The standard configuration is reflected in the following printout provided that no
parameters have been changed.
3.2.1 Standard Configuration for Printer CI - 4040
PRINT OUT VERSION 20xxxxxx
INTERFACE ADJUSTMENT
BUFFER 8 KBYTE AGC POSITION 24
WORD LENGTH 8 BIT PLATEN GAP 0
I/F TYPE PARALL./ RS232 PAPER-IN ADJ. 0 *)
BAUD-RATE 9600 BPS CUT. V-POS 0
PARITY BIT IGNORE UNI-DIRECT.CMD YES
PROTOCOL DTR TRACT. FF-MODE IGNORE FF
CTS MODE CTS IGNORE
MENU ACCESS ALL FUNCTIONS
CURRENT SETTINGS MACRO 1* MACRO 2 MACRO 3 MACRO 4
FONT DATA DATA DATA DATA DATA
PRINT QUALITY LQ LQ LQ LQ LQ
GRAPHICS QUAL. STANDARD STANDARD STANDARD STANDARD STANDARD
SUB/SUPER FONT YES YES YES YES YES
PITCH 10 CPI 10 CPI 10 CPI 10 CPI 10 CPI
LINE 6 LPI 6 LPI 6 LPI 6 LPI 6 LPI
PAGE LENGTH 72 LINES 72 LINES 72 LINES 72 LINES 72 LINES
TRACTOR V-POS 0 0 0 0 0
MANUAL V-POS 0 0 0 0 0
LEFT MARGIN 1 COLUMNS 1 COLUMNS 1 COLUMNS 1 COLUMNS 1 COLUMNS
RIGHT MARGIN 136 COLUMNS 136 COLUMNS 136 COLUMNS 136 COLUMNS 136 COLUMNS
TOP MARGIN 1 LINES 1 LINES 1 LINES 1 LINES 1 LINES
BOTTOM MARGIN 1 LINES 1 LINES 1 LINES 1 LINES 1 LINES
PERF. SKIP YES YES YES YES YES
PAPER SOURCE TRACTOR TRACTOR TRACTOR TRACTOR TRACTOR
PAPER EXIT BATCH BATCH BATCH BATCH BATCH
EMULATION EPSON LQ EPSON LQ IBM PROPR. IBM PROPR. AGM EPSON LQ
CHARACTER SET EPSON EXT.GCT EPSON EXT.GCT IBM SET 2 IBM SET 2 EPSON EXT. GCT
3: GERMANY 3: GERMANY 1: U.S.A. 1: U.S.A. 1: U.S.A.
LINE MODE LF=LF, CR=CR LF=LF, CR=CR LF=LF, CR=CR LF=LF, CR=CR LF=LF, CR=CR
$$-COMMAND NO NO NO NO NO
TEAR-OFF-MODE NO NO NO NO NO
Note: An asterisk (’) after MAKRO 1 indicates the actual macro.
*) This value is dependent on factory setting!
All this standard settings of the firmware will be restored with the menu function
RECALL FACTORY.