Filter
Top Products
Configuring the printer
3-18
+/- 1 = +/- / " = +/- 0,42 mm
1
60
+/- 2 = +/- / " = +/- 0,85 mm
2
60
+/- 3 = +/- / " = +/- 1,27 mm
3
60
+/- 4 = +/- / " = +/- 1,69 mm
4
60
+/- 5 = +/- / " = +/- 2,12 mm
5
60
+/- 6 = +/- / " = +/- 2,54 mm
6
60
+/- 7 = +/- / " = +/- 2,96 mm
7
60
+/- 8 = +/- / " = +/- 3,39 mm
8
60
+/- 9 = +/- / " = +/- 3,81 mm
9
60
+/- 10 = +/- / " = +/- 4,23 mm
10
60
+/- 11 = +/- / " = +/- 4,66 mm
11
60
+/- 12 = +/- / " = +/- 5,08 mm
12
60
+/- 13 = +/- / " = +/- 5,50 mm
13
60
+/- 14 = +/- / " = +/- 5,93 mm
14
60
+/- 15 = +/- / " = +/- 6,35 mm
15
60
+ 16 = + / " = + 6,77 mm
16
60
S CUTTING V-POS
This parameter can be used to compensate mechanical tolerances which
may cause a misalignment between the perforation edge of a continuous
form and the tear-off position as well as the cutting position, in case the
cutting option is installed.
If no cutting device is mounted the value of CUTTING V-POS will influence
the TEAR-OFF Position.
The range within which variations can be met is - / " to + / ", where "-"
15 16
60 60
is up the page and "+" is further down the page.
The following table shows the possible values in inch and millimetres.
Note: If, for some reason, it is not desired to cut exactly on the perforation it is
very important to cut below the perforation of the printed page. If the
paper is cut above the perforation the remaining paper can easily bend and
cause a paper jam. Do not cut through a label as the blade would get dirty
by the glue.
S Uni-Direct.CMD
If NO is selected, commands for uni-directional printing will be ignored. The
default setting of YES means that commands will be carried out to switch
from bi-directional to uni-directional or vice versa.