Filter
Top Products
Switching to the Target Image by Remote Control
You can change directly to the target image by pressing the following
buttons on the remote control.
The input ports for each button are shown below.
Remote control
Input Port
E
Changes to images from a computer connected via the network.
F
EB-G6750WU only
Adjusting the Volume
You can adjust the volume using one of the following methods.
• Press the [Volume] button on the remote control to adjust the volume.
[
a] Decreases the volume.
[
b
] Increases the volume.
Remote control
• Adjust the volume from the Configuration menu.
s Settings - Volume p.84
Caution
Do not start at high volume.
A sudden excessive volume may cause loss of hearing. Always lower the volume
before powering off, so that you can power on and then gradually increase the
volume.
Projecting Images
42