Filter
Top Products
19
Configuration Menu Functions
Configuration Menu
If aspect is set to "Zoom" when viewing images with subtitles, change the setting as
follows so that the subtitles are visible. The vertical size and the display position can
both be adjusted together.
•
Vertical Size
The vertical size of the
image is reduced so that the
subtitles are displayed.
0
•
Zoom Position
The whole of the image is
moved up so that the
subtitles are displayed.
Median value (0)
This is used to correct keystone distortion in images. The same correction can be
carried out using the projector's control panel.
Setup Guide
Median value (0)
This should be set in accordance with the method used to set up the projector.
•
Front : Select when the projector is set up in front of the screen.
•
Front/Ceiling : Select when the projector is set up in front of the screen and
suspended from a ceiling.
•
Rear : Select when the projector is set up behind the screen.
•
Rear/Ceiling : Select when the projector is set up behind the screen and suspended
from a ceiling.
Front
The projector is equipped with a power-saving function that causes the power to turn off
automatically and the projector to switch to standby if no signal is input to the projector
for a continuous length of time. The length of time before the power-saving function
operates can be selected from four available settings. If "OFF" is selected, the power-
saving function will not operate.
If you press while the projector is in standby mode, projection will start again.
30min.
This selects the port that is used to connect a computer when using the Cinema Color
Editor to adjust the picture quality of images from the computer.
If you change the setting, the new setting will take effect after the power has been turned
off and the cool-down
period is complete.
USB
*1 The setting values are stored separately for each image source and signal type.
Zoom Caption *
1
Subtitle section
Use "Zoom Position" to
change the display position
of the image.
Use "Vertical Size" to
reduce the image size.
Projection area
Keystone
Projection
Default setting
Operation
Sleep Mode
COM Port
TW200-E.book Page 19 Monday, September 1, 2003 5:19 PM