Filter
Top Products
21
Configuration Menu Functions
Configuration Menu
This sets whether the start-up screen (the image that is projected when projection starts)
is displayed (ON) or not displayed (OFF).
If you change the setting, the new setting will take effect after the power has been turned
off and the cool-down
period is complete.
ON
(Adjustment is only possible when composite video or S-Video signals are being
input)
This sets the video signal format. If "Auto" is selected, the video signal format is set
automatically. If there is a lot of interference in the image, or if a problem such as no
image being projected occurs even though "Auto" has been selected, select the correct
signal format.
Auto
Change this setting depending on the type of signal that is being output from the video
equipment that is connected to the [InputA] port.
YCbCr
Select "YCbCr" or "YPbPr " depending on the type of signal that is being output by
the source that is connected to the [D4] port.
YCbCr
This sets the display language for messages and menus.
English
(Varies depending on
country of purchase)
This returns all settings in the "Setting" menu to their default settings, except for the "Input Signal" and
"Language" settings.
Startup Screen
Default setting
Input Signal
Video Signal
Input A
D4
Default setting
Language
Reset
TW200-E.book Page 21 Monday, September 1, 2003 5:19 PM