Filter
Top Products
33
Configuration Menu Functions
Configuration Menu
"Settings" menu
(Setting is possible only when "EPSON Super White" is "Off". Setting is not possible, however, when
"Color Mode" is set to "x.v. Color.")
When the [HDMI1] / [HDMI2] input port of the projector is connected to a DVD player, for example, set
the video range of the projector to suit the video range setting of the DVD player. The setting at the DVD
player can be either Normal or Expand.
(This setting can be made only when a 1080p/24Hz signal is being input to the [Component] or
[HDMI1], [HDMI2] input terminals.)
For a 1080p/24Hz input signal, you can select between 2-2 pull-down projection or 2-3 pull-down
projection. Selecting "On" sets the 2-2 pull-down.
All the adjustment values on the "Signal" menu, except "Aspect
", are returned to their default values.
When the main power switch is turned on, you can set for projection to start (On) / not start (Off) without
pressing or .
When set to "On" with the main power switch left on, be aware that sudden surges of electricity that may
occur when the power comes back on after a power outage may cause the projector to turn on.
The projector is equipped with a power-saving function that causes the power to turn off automatically
and the projector to switch to standby if no signal is input to the projector for a continuous length of time.
The length of time before the power-saving function operates can be selected from four available settings.
If "Off" is selected, the power-saving function will not operate.
If you press while the projector is in standby mode, projection will start again.
This locks the power on function of the button on the projector's control panel, so that a child cannot
accidentally turn the projector's power on and look into the projector's lens. When the lock is applied, the
power will only turn on if is pressed down for about 3 seconds. can be used to turn off the power,
and the remote control will continue to operate as normal.
If you change the setting, the new setting will take effect after the power has been turned off and the cool-
down period is complete.
Even if "Child Lock" is set to "On", be aware that projection starts merely by turning the main power
switch on when "Direct Power On" is set to "On".
If this is set to "On", you can't operate the projector's control panel buttons and a icon appears on the
screen when a button is pressed. To cancel, press and hold
on the projector's control panel for about
seven seconds or more.
If you change the setting, the new setting will take effect after exiting the configuration menu.
Displayed for input sources other than computer
HDMI Video Range
*1
2-2 Pull-down
Reset
Direct Power On
Sleep Mode
Child Lock
Operation Lock
*1 The setting values are stored separately for each image source and signal type.