Filter
Top Products
34
Adjusting the Image Angle
The projector should be set up so that it is as perpendicular to the screen as
possible.
If it is not possible to set up the projector so that it is perpendicular to the
screen, it can be set up at a slight vertical angle instead. You can extend or
retract the front adjustable feet to adjust the projection angle within a maximum
range of 10º.
Procedure
While pressing the two foot adjust
buttons at either side, lift up the front
of the projector so that the front
adjustable feet can extend.
Extend the front adjustable feet until the
desired angle is obtained, and then release the
foot adjust buttons.
To retract the front adjustable feet, gently push
down on the projector while pressing the two
foot adjust buttons.
Tip :
• When the foot is adjusted, it may cause the projected images to become distorted. Use
the keystone correction function to adjust this distortion. (p.35)
Seen from the side Seen from above
9.6
1
Foot adjust buttons
(side)
Adjusting the Screen Image
Centre of
lens