Filter
Top Products
77
4
Take out the lamp.
Hold the lamp by the two tabs to lift it up
and out from the projector.
5
Install the new lamp.
Hold the lamp so that it faces the correct
way to fit into the projector, and then
insert the lamp and tighten the two lamp
fixing screws.
6
Install the lamp cover.
Slide the cover in from the outside, and
then push it in until it clicks into place.
Tip :
• Install the lamp securely. If the lamp cover is removed, the lamp turns off automatically
as a safety precaution. Moreover, the lamp will not turn on if the lamp or the lamp
cover is not installed correctly.
• Spare lamps are provided with a spare air filter. The air filter should also be replaced
when the lamp is replaced. (p.79)
• Dispose of used lamps properly in accordance with your local regulations.
The projector has a built-in counter which keeps track of the lamp operating
time. When the cumulative operating time reaches a certain point, it causes the
replacement warning message to be displayed. Therefore, the counter needs to
be reset after the lamp has been replaced with a new one. You can do this using
the configuration menu.
Tip :
Do not reset the lamp operating time except after the lamp has been replaced, otherwise
the lamp replacement period will not be indicated correctly.
Resetting the Lamp Operating Time
Maintenance