Filter
Top Products
Turning the Equipment On and Off
■ ■ ■ ■ ■
■
35
Turning the Equipment On and Off
Turn on the projector and its attached equipment in the
following order.
1. Video source
2. Audio source (if different from computer or video source)
3. Projector
4. External speaker or PA system
5. Computer
When you turn off the equipment, do so in the reverse order.
Turning the Projector On and Off
1. Remove the projector lens cap.
2. When you plug in the projector power cord, the power
indicator flashes orange for few seconds. Then the light
remains orange.
3. Press the Power button on the remote control or
operation panel. The power indicator flashes green as the
projector warms up. When the projector is fully warmed
up, this light remains green.
If computer or video equipment is attached, the computer or
video signal is projected.
Allow about 30 seconds for full illumination.
♦ Warning: Never look into the lens when the lamp is on. This can
damage your eyes. It is especially important that children are not
allowed to look into the lens.
♦ Caution: When turning the projector on or off with the remote
control, be sure to turn the remote control on first with the power
switch.